Axe-Fx III Firmware Release Version 13.00

zen

Active member
Mitglied seit
Okt 2, 2012
Beiträge
774
http://www.fractalaudio.com/downloads/firmware-presets/axe-fx-3/13p0/axefxiii_dsp_rel_13p00.zip

13.00

Improved Drive block modeling. New algorithm uses a novel solution to solve the nonlinear ODE of a diode clipper with memory (i.e. a capacitor). The accuracy of the diode I-V curve is also greatly improved. This new algorithm has the accuracy of implicit iterative solutions with speed rivaling explicit solutions. CPU usage is only slightly increased vs. the previous algorithm. Note that many of the Drive models will now behave differently and presets should be auditioned. The behavior of the tone controls in some models has also changed. Of note are the Timmy models where the tone controls are now faithful to the actual pedal and decrease bass/treble when turned clockwise.

The Drive block now features a “Bass Response” control for types based on the Rat, Tube Screamer and various derivates. In some models this is duplicated on the Basic page as it is the Bass/Voice/etc. control (and renamed accordingly). This function was previously provided by the Low Cut control. The Low Cut control is now a separate control that allows adjusting the input highpass frequency. Existing presets will automatically be updated with the new default value for the Low Cut control.

Added Bias control to GUI of all Drive block models.

Added “Headroom” monitoring meter to Amp block. The most common reason for “muddy” tones with high-gain amps is incorrect setting of the Master Volume control. The Headroom meter displays the voltage at the virtual power tubes in dB. If the Master Volume is too high the meter will be near 0 dB most of the time. Note that this only applies to amps where the power amp is intended to run “clean” like the 6160, Recto, etc. Non-Master Volume amps get their distortion from the power amp distorting so this recommendation does not apply.

Added Global EQ to all outputs. Note that the EQ for Outputs 3 and 4 is not active if that output has Copy Input 1 set and the corresponding Output block is not in the patch.

Added selectable Graphic/Parametric EQ for Global Output EQs.
 
Oben
mainframe-fourhanded
mainframe-fourhanded