M
mrgodin
Guest
And here it is ...
https://forum.fractalaudio.com/threads/axe-fx-ii-quantum-rev-9-00-firmware-release.131649/
*******************************************************************************
9.00
Removed the “Motor Drive” and “Transformer Grind” algorithms and associated parameters from the Amp block. These have been replaced by the new “Speaker Compression” algorithm. This algorithm models the interaction of the power amp with the power compression of the virtual speaker. The “Spkr Comp” parameter controls the amount of virtual speaker compression. This value defaults to 3.0 when the Amp block is reset. It does not get reset when changing the model. If using the Axe-Fx II with a tube power amp and conventional guitar cab you may want to reduce this value to 0.0. The gain reduction meter shows the amount of virtual power compression (select the Spkr Comp knob to monitor the gain reduction). Typical guitar speakers compress between 3 and 6 dB depending upon construction, age, volume, etc. The default value is conservative and yields about 3 dB of compression.
Note that the Master Volume control will interact considerably with the Speaker Compression algorithm as will the Presence and Depth controls. Higher values of Master Volume will cause more virtual speaker compression.
Improved Delay block. Also reworked the Deluxe Mind Guy, Mono BBD and Stereo BBD delay models based on the improvements.
Added “Blackglass 7K” Drive model based on a Darkglass B7K. The model was obtained with the Attack and Grunt switches in the middle positions. The Grunt switch changes the low-cut frequency therefore the Low Cut control can be used to replicate this switch. The Attack switch controls a shelving filter on the input and can be replicated using the Tone control.
*******************************************************************************
Daran denken, dass der Axe-Edit noch aktualisiert werden muss!
Wegen der geänderten & entfernten Parameter!
https://forum.fractalaudio.com/threads/axe-fx-ii-quantum-rev-9-00-firmware-release.131649/
*******************************************************************************
9.00
Removed the “Motor Drive” and “Transformer Grind” algorithms and associated parameters from the Amp block. These have been replaced by the new “Speaker Compression” algorithm. This algorithm models the interaction of the power amp with the power compression of the virtual speaker. The “Spkr Comp” parameter controls the amount of virtual speaker compression. This value defaults to 3.0 when the Amp block is reset. It does not get reset when changing the model. If using the Axe-Fx II with a tube power amp and conventional guitar cab you may want to reduce this value to 0.0. The gain reduction meter shows the amount of virtual power compression (select the Spkr Comp knob to monitor the gain reduction). Typical guitar speakers compress between 3 and 6 dB depending upon construction, age, volume, etc. The default value is conservative and yields about 3 dB of compression.
Note that the Master Volume control will interact considerably with the Speaker Compression algorithm as will the Presence and Depth controls. Higher values of Master Volume will cause more virtual speaker compression.
Improved Delay block. Also reworked the Deluxe Mind Guy, Mono BBD and Stereo BBD delay models based on the improvements.
Added “Blackglass 7K” Drive model based on a Darkglass B7K. The model was obtained with the Attack and Grunt switches in the middle positions. The Grunt switch changes the low-cut frequency therefore the Low Cut control can be used to replicate this switch. The Attack switch controls a shelving filter on the input and can be replicated using the Tone control.
*******************************************************************************
Daran denken, dass der Axe-Edit noch aktualisiert werden muss!
Wegen der geänderten & entfernten Parameter!