tomsmusicdreams
Active member
- Mitglied seit
- Okt 16, 2021
- Beiträge
- 277
Here is the new Axe-Edit:
Axe-Edit III 1.12.03 (to support fw 20.01 public beta 2)
Axe-Edit III 1.12.03 provides support for Axe-Fx III firmware 20.01 public beta 2. The editor is available below: OSX: https://www.fractalaudio.com/downloads/Axe-Edit-III/Axe-Edit-III-OSX-v1p12p03.dmg Win64: https://www.fractalaudio.com/downloads/Axe-Edit-III/Axe-Edit-III-Win-v1p12p03.exe...
forum.fractalaudio.com
20.01
Added Speaker Thump control to Amp block. Speaker Thump models the dynamic, nonlinear behavior of a guitar speaker. A value of 5.0 roughly corresponds to an amplifier running into a speaker rated at the same power as the amplifier, i.e., a 100W amplifier running into a 100W speaker. The reset value is a conservative 2.5 which represents, i.e., a 50W amp running into a 100W speaker. Note that the majority of the response is in the subsonic region and the effect is primarily tactile. Existing presets are not affected and the value will be zero.
Decreased minimum diffuser time in Delay block to 1%.
Added G12T-75 speaker impedance curve.
Added Depth control to Authentic page for Brit Super, Brit 800 Mod and JMP-1 amp models.
Fixed switching channels on Drive block can cause pop.
Fixed switching channels on bypassed blocks can cause an audio gap.
FC: Fixed all FC "Effect" functions (Bypass and Channel, Global and Per-Preset) so they no longer change to an incorrect block when you upgrade from firmware 19.08 or older, or when you restore backups created under the same. NOTE: If you previously installed firmware 20.00 (beta or release) and manually saved changes to global or per-preset "Effect" switches, you may need to manually adjust switch settings again, or import backups created in firmware 19.08 or earlier.
FC: Fixed Factory Default layouts so FX Bypass and Channel switches use the correct blocks.
FC: Fixed an issue that prevented the Hold function from working correctly for some Stand-in Switches.
Various other fixes and improvements.
