tomsmusicdreams
Active member
- Mitglied seit
- Okt 16, 2021
- Beiträge
- 277
Axe-Fx III Firmware Release Notes
23.03
Improved CPU usage.
Added "Nobelium OVD-1” Drive model based on a Nobels ODR-1. The BC (Bass Cut) switch is modeled via the Bass Response control. Set the Bass Response to 1.0 to duplicate the response of the pedal with the Bass Cut switch engaged. Set Bass Response to 5.0 to duplicate response with BC switch disengaged.
Added Sunrise Splendor model based on a JHS Morning Glory.
Added Gauss Drive model based on a Mesa Flux Drive.
Added Brit 800 2203 models.
Renamed Brit 800 to Brit 800 2204 High.
Added Brit 800 2204 Low model.
Added 5153 100W Stealth amp models.
Added USA MKV Green amp model.
Changed default values of Speaker Drive and Speaker Thump to better align with measurements of typical speakers.
Added NFB Compensation switch in Amp block. This defaults to On. Turning it off disables the negative feedback volume compensation at the output of the Amp block.
Fixed LFO2 not working in Chorus block.
Fixed wrong Distortion pot taper in DS1 Distortion models.
Fixed wrong Gain pot taper in Angle Severe models.
Fixed wrong output pad in USA JP IIC+ Green model.
Fixed wrong default tonestack in 1959SLP and Plexi 100W 1970 models.
Fixed EQ graphs in some blocks not updating when resetting the channel.
Fixed Output Configuration being overridden by Copy parameter. I.e., if Output 2 Configuration is set to Copy L->R but Copy Output 1 is ON then the output would have the same configuration as Output 1 (e.g., Stereo).
Various other fixes and improvements.