Ichl
Active member
Axe-Fest 2023 Teilnehmer
Axe-Fest 2022 Teilnehmer
Axe-Fest 2019 Teilnehmer
Axe-Fest 2018 Teilnehmer
Axe-Fest 2017 Teilnehmer
- Mitglied seit
- Okt 12, 2012
- Beiträge
- 191
Hallo,
FW 10.02 ist raus... http://forum.fractalaudio.com/axe-fx-ii-discussion/68306-firmware-version-10-02-now-available.html
Sind wohl ein paar kleine Bugs beseitigt worden und ein Plexi ist dazugekommen...
10.02
Changed USA Pre Green and USA Pre Yellow amp models to have power amp sim active by default (Supply Sag nonzero).
Increased output level of Division 13 and Shiver Clean amp models based on customer feedback.
Added “Plexi 100W Nrml” model.
Removed pass-through of MIDI Clock messages as this causes excessive lag when using MFC-101 via the CAT-5 connection.
Fixed Amp block speaker impedance graph “shifting”.
Fixed sync message not sent to Axe-Edit when changing bypass state via front panel.
Fixed parameter text being overwritten when a Scene Select is received over MIDI.
*******************************************************************************
10.01
Added Mode parameter to Tone Match block. When sst to “Offline” the algorithm is optimized for non-real-time matching, i.e. matching a recording. When set to “Live” the algorithm is optimized for matching a live source such as an amp. Note that the Live mode can also be used for matching recordings and, in some cases, may achieve better results than Offline mode.
Fixed crashing due to bug in Looper block.
FW 10.02 ist raus... http://forum.fractalaudio.com/axe-fx-ii-discussion/68306-firmware-version-10-02-now-available.html
Sind wohl ein paar kleine Bugs beseitigt worden und ein Plexi ist dazugekommen...
10.02
Changed USA Pre Green and USA Pre Yellow amp models to have power amp sim active by default (Supply Sag nonzero).
Increased output level of Division 13 and Shiver Clean amp models based on customer feedback.
Added “Plexi 100W Nrml” model.
Removed pass-through of MIDI Clock messages as this causes excessive lag when using MFC-101 via the CAT-5 connection.
Fixed Amp block speaker impedance graph “shifting”.
Fixed sync message not sent to Axe-Edit when changing bypass state via front panel.
Fixed parameter text being overwritten when a Scene Select is received over MIDI.
*******************************************************************************
10.01
Added Mode parameter to Tone Match block. When sst to “Offline” the algorithm is optimized for non-real-time matching, i.e. matching a recording. When set to “Live” the algorithm is optimized for matching a live source such as an amp. Note that the Live mode can also be used for matching recordings and, in some cases, may achieve better results than Offline mode.
Fixed crashing due to bug in Looper block.