Gitjester
Active member
- Mitglied seit
- Sep 30, 2012
- Beiträge
- 149
http://www.fractalaudio.com/downloads/firmware-presets/axe-fx-3/11p0/AxeFX_3_Factory_Banks_v11p0.zip
Axe-Fx III Firmware Release Notes
11.00
Amp block now uses new high-order speaker impedance modeling. 52 speaker impedance models (and
two LB-2 models) are included and can be selected using the Speaker Impedance Curve parameter (on
the Advanced page). Selecting an amp model will load an appropriate default Speaker Impedance Curve
for that amp model. The Cabinet Resonance parameter can be used to adjust the amount of cabinet
resonance in the impedance curve. NOTE: The 2x12 Bassguy, 2x12 Jazz 120, 4x10 Brit JM45 and 4x12
Hipower data is incomplete and will be updated in a future release.
Setting Global “Update Pre-11.x Presets Spkr Imp Upon Load" parameter to YES will automatically
update the Speaker Impedance Curve for the Amp blocks upon preset recall to use an appropriate
Speaker Impedance Curve for that amp model. Setting the parameter to NO will leave existing presets
unaffected. NOTE: Setting this to YES will also cause the EDITED LED to light indicating the preset has
been modified.
Fixed Recto1/2 models default Negative Feedback and Power Tube Bias values slightly too low.
Fixed loss of precision in Drive block Tone control for some models (Rat, Timothy, et. al.) causing low
frequency build-up over time.
Zuletzt bearbeitet: